Plans

Three tables

Below you'll find three tables:

• Original sizes, according to Nick Schade, but converted to metric values (all milimeters) (This in my work, not Nick's. Any complaint mail me).
• Measures, adapted for the narrower plywood we obtain here.
• Table with vertical cuts, which can be used to make templates to estimate the form of the hull. Emphasis on estimate! Some of the templates fit up to 0.5 meters from the indicated offset. Still, they're very usefull.

Table 1: Original measures

Original sizes, according to Nick Schade, but converted to metric values (all milimeters) (This in my work, not Nick's. Any complaint mail me).

The panes of plywood in the U.S. seem to be be a few cm wider than here, and the original position of the parts didn't fit. Luckily, just moving them a bit closer, all was well.

 

Table 2: Measures with offset

The left column indicates the separation of the vertical lines. Each line then contains the marks to be made on these vertical lines. Check the usage page for more details.

NOTE: There are more lines in the table than in Nick's drawing. That drawing only contains the main vertical lines each 6 or 12 inches. The table is more complete!

Table 3: Templates

This is the original table, but again, translated to metrics. The information is the same as on the author's site, with the same problem. The templates do not fit exactly at the place indicated. But they are still quite helpfull.

---

(c) John Coppens ON6JC/LW3HAZ

correo