[SI-LIST] : Electrical Analysis to prove the soundness of a design

About this list Date view Thread view Subject view Author view

From: ªL´Â·× ([email protected])
Date: Fri Oct 27 2000 - 03:35:03 PDT


Dear SI gurus,

After designing a system, how do we do Electrical Analysis to prove the
soundness of this design?
I know it is a very wide question. However, it is also a very important
question for a hardware engineer.
How many tests are needed for the analysis? What are them?

For example,
1. signal quality measurement.
2. Timing measurement.
3. Clock skew and jitter measurement.
4. Power/Ground noise measurement.
5. Bare board impedance measurement.
6. ....

Would somebody please shed light on it?
Thanks,

John Lin
SI Engineer, ARD4
Quanta Computer Inc.,Taiwan, R.O.C.
Email: [email protected]
Tel: 886+3+3979000 ext. 5183

**** To unsubscribe from si-list or si-list-digest: send e-mail to
[email protected]. In the BODY of message put: UNSUBSCRIBE
si-list or UNSUBSCRIBE si-list-digest, for more help, put HELP.
si-list archives are accessible at http://www.qsl.net/wb6tpu
****


About this list Date view Thread view Subject view Author view

This archive was generated by hypermail 2b29 : Tue May 08 2001 - 14:29:52 PDT