From: Bob Lewandowski ([email protected])
Date: Fri Sep 22 2000 - 16:53:08 PDT
Not really. It's the total length of the current loop, not just the body
inductance of the capacitor alone. A 25 mil deep via hole at each end of the
capacitor alone will roughly double the 0.6 nH 'specified' body inductance.
That does not include the pads and traces to get from the capacitor to the vias.
For decoupling an IC lead the usual killer is the lead and bond wire inductance
back to the chip. Usually several nH.
John Kennedy wrote:
> "Muhammad S. Sagarwala" wrote:
> > 0508 caps with 1nh ESL????I am looking at the AVX specs and they list the
> > ESL to be 0.6nh.
> > I am pretty sure Murata specs them to be less than 1nh too...I would
> > recommend checking the
> > ESL spec. again...
> I agree that the values are lower in the specs, but I had rounded up to
> account for via/pad effects. Is this not a reasonable assumption?
> **** To unsubscribe from si-list or si-list-digest: send e-mail to
> [email protected] In the BODY of message put: UNSUBSCRIBE
> si-list or UNSUBSCRIBE si-list-digest, for more help, put HELP.
> si-list archives are accessible at http://www.qsl.net/wb6tpu
**** To unsubscribe from si-list or si-list-digest: send e-mail to
[email protected] In the BODY of message put: UNSUBSCRIBE
si-list or UNSUBSCRIBE si-list-digest, for more help, put HELP.
si-list archives are accessible at http://www.qsl.net/wb6tpu
This archive was generated by hypermail 2b29 : Tue May 08 2001 - 14:29:34 PDT