From: Greim, Michael ([email protected])
Date: Mon Jun 12 2000 - 07:46:17 PDT
Hi Everyone,
Does any of you have a good reference or set of equations
regarding the current handling capability of etch. I am
interested in absolute maximum as well as good design
practice ratings. I have some devices that have wired powers
and while the frequency requirements are low, I am con-
cerned about current handling capability. The two pieces
of etch that I am concerned about is a half oz. 4 mil wide
etch and 1.5 oz 6 mil wide etch.
Thanks in advance for the assistance.
Best Regards,
Michael Greim
**** To unsubscribe from si-list or si-list-digest: send e-mail to
[email protected]. In the BODY of message put: UNSUBSCRIBE
si-list or UNSUBSCRIBE si-list-digest, for more help, put HELP.
si-list archives are accessible at http://www.qsl.net/wb6tpu
****
This archive was generated by hypermail 2b29 : Wed Nov 22 2000 - 10:50:34 PST