[SI-LIST] : basic design question

About this list Date view Thread view Subject view Author view

From: Adam Klein (Aklein@drawbridge3.simpletech.com)
Date: Tue Jun 05 2001 - 16:20:48 PDT


I have a 133MHz DUT Board with 50 OHM traces, I have one output from the
tester driving a signal which needs to reach the connector in two different
locations but if I "T" the signal i will receive reflections on the signal
is there another solution which would reduce reflections, and keep the
signal clean.

Thanks
Adam

**** To unsubscribe from si-list or si-list-digest: send e-mail to
majordomo@silab.eng.sun.com. In the BODY of message put: UNSUBSCRIBE
si-list or UNSUBSCRIBE si-list-digest, for more help, put HELP.
si-list archives are accessible at http://www.qsl.net/wb6tpu
****


About this list Date view Thread view Subject view Author view

This archive was generated by hypermail 2b29 : Thu Jun 21 2001 - 10:12:16 PDT