[SI-LIST] : basic design question

About this list Date view Thread view Subject view Author view

From: [email protected]
Date: Wed Jun 06 2001 - 02:03:17 PDT


Hi Adam,

Why don't you try using Daisy chin configuration where you can keep all the
devices equally placed.
Try simulating the configuration and then decide the trace length,

We also have used T architecture and found it to work fine.

Thanks
Vikas

Date: Tue, 05 Jun 2001 16:20:48 -0700
From: Adam Klein <>
Subject: [SI-LIST] : basic design question

I have a 133MHz DUT Board with 50 OHM traces, I have one output from the
tester driving a signal which needs to reach the connector in two different
locations but if I "T" the signal i will receive reflections on the signal
is there another solution which would reduce reflections, and keep the
signal clean.

Tha

**** To unsubscribe from si-list or si-list-digest: send e-mail to
[email protected]. In the BODY of message put: UNSUBSCRIBE
si-list or UNSUBSCRIBE si-list-digest, for more help, put HELP.
si-list archives are accessible at http://www.qsl.net/wb6tpu
****


About this list Date view Thread view Subject view Author view

This archive was generated by hypermail 2b29 : Thu Jun 21 2001 - 10:12:16 PDT