BACK TO HOME PAGE INDEX

The Montreal Fox V3  fully compatible with International Hunts in zone 2 (ARDF).

Hardware by Jacques VE2EMM.
Software by Francois VE2JX and Jacques VE2EMM.
Special thanks to Joe Leggio WB2HOL and Doug Reed N0NAS.

This project is free for non commercial use by Ham radio operators only.


 FEATURES
                                 Montreal Fox  TOP VIEW
                              Montreal Fox    BOTTOM VIEW

SOLDERING SURFACE MOUNT DEVICES

1-    Using a very small soldering iron tip, put a small quantity of solder on a corner pad.
2-    Position  the device carefully with pair of tweezers.
3-    Solder that corner pin while maintaining the alignment of the device on all the pads.
4-    Solder the rest of the pins with a very small amount of solder.
INFORMATION
  • Spectrum analysis of the Fox output (46K).
  • Features and operation text. V 3 includes elemination of key clicks.
  • Construction text.
  • Parts list V 3     Get information on the availlability of the ICS501 from ICS.

  • You can buy the FET from     http://www.jdr.com      1-800-538-5000
  • Use a PIC16F628 for all new construction, it cost less and is a better performer.

  • Fine print:
    All material on this page is distributed on a WYSIWYG basis and as such I can't take any responsibility for the use of this design and its results. However in saying this it must also be mentioned that every effort  has been taken to ensure that it as error free as possible.

    BACK TO HOME PAGE INDEX
    Many thanks to Al Waller K3TKJ for graciously hosting my web pages on QSL.NET.