INDICADOR DE SINTONIA PARA
ANTENAS E ACOPLADORES
Utiliza baixa potencia.
É fácil de montar e baixo
custo.
Útil no ajuste de
acoplamento de antena sem o uso de transmissores.
Útil na verificação da
freqüência em que a impedância seja de 50 Ohms.
Esquema
Detalhe do oscilador veja
em LINK
Montagem:
A bobina L1 foi montada em
núcleo de pó de ferro utilizado em baluns de TV. O fio não é critico, obedeça
ao numero de espiras e a fase (inicio de enrolamento indicado pela letra “o” no
esquema).
Ajustes
1. O led deve ficar aceso
em todo o espectro de HF
2. O led deve apagar em
todo espectro de HF com um resistor de 56R ligado ao invés da antena.
Caso com a antena em curto
circuito, o led não permanecer aceso em freqüências altas, um capacitor de
73 de PY2OHH Miguel
ANTENNA MATCH
- Low power.
- Ease to build and low cost.
- No transmitter needed to adjust you ATU.
- Ease to find the frequency where your antenna impedance matches with
50 ohms.
Schematics.
For details of oscillator section look at LINK.
Building tips
L1 coil was built in dust iron toroid like FB801.
The wire diameter, toroid size or type is not important. Attention only
in turns ratio and phase (beginning of the coil indicate in the schematics by
“o”).
Tests and Adjustment
If in high frequencies in the test number two the LED goes out, the
capacitor indicated 10 to 100pf in the schematics needs to be adjusted until
all the tree conditions will be OK.
GOOD LUCK
73 de PY2OHH Miguel