2.1.1.8.1 Function buttons (marker #8 of image 2.1.1)
SERVO ENABLE - This control is initialized by the program when powering up to determine how many servos are online ( 1 or 2 ) and then give the operator the ability to select which unit(s) will be used and if both are selected how they will interact.
The following four images are descriptive of a 2 unit system where all functions are available
if only one servo was powered on or available then only the U1 enabled or U2 enabled selectors would function
System will use U1 only all functions related to U2 or multiple systems capabilities will be
darkened and not available for use.
System will use U2 only all functions related to U1 or multiple systems capabilities will be
darkened and not available for use.
System will use both U1 and U2, U1 will provide the BPM setting insuring sync lock, all
functions not related to this configuration will be darkened and not available for use
System will use both U1 and U2, BPM settings are independent, all
functions not related to this configuration will be darkened and not available for use.