Taking the USB adapter apart is simple. Crack the case open and toss all the parts except for the PC board. Find the + 12 and ground connections and solder a foot of wire on them then heat shrink the PC board. |
The T-Tap clamps around a wire to allow a male 1/4" connector to mate. Looking at the Tap you can see a fork. That fork is what accepts the flat male connector. |
The Lido isn't the best choice for this application. I used it because I had it left over from another project. Ram Products makes a all in one mount for cell phones that I would choose if I would do this again. |
Searching Ebay for "Mpow cell mount" will find a host of sellers. It doesn't matter what one you buy because the only part needed is the cell phone "grabber". The rear is mated to the Lido LM700 via your own hardware.
|