The information on this page is subject to the terms and conditions set forth on the ICOM America Service FAQ Index page.
Symptom: |
![]() |
Radio will not transmit or receive after warm-up. |
![]() |
||
Probable Cause: | PLL unlock. | |
![]() |
||
Cure: | Replace unstable C228 with a ceramic equivalent and adjust the lock voltage for 2 volts instead of 2.5 volts as stated in the manual. | |
![]() |
![]() |
![]() |
Symptom: |
![]() |
Carrier output when mic is keyed in SSB mode, distorted TX audio. RF feedback. |
![]() |
||
Probable Cause: | RF feedback. | |
![]() |
||
Cure: | Add a ground jumper at J10, pin 4 on main unit. | |
![]() |
![]() |
![]() |
Symptom: |
![]() |
Won't operate tuner. |
![]() |
||
Probable Cause: | S1 and/or S2 on the logic are not set in the proper position. Q52 may be bad. | |
![]() |
||
Cure: | Set switches correctly. Check Q52 for failure. | |
![]() |
![]() |
![]() |
Symptom: |
![]() |
No display. |
![]() |
||
Probable Cause: | IC5 and C12 blown on logic unit. | |
![]() |
||
Cure: | Replace blown IC5 and C12. | |
![]() |
![]() |
![]() |
Symptom: |
![]() |
Radio won't turn off. |
![]() |
||
Probable Cause: | Bad Q1 on relay unit. | |
![]() |
||
Cure: | Replace Q1. | |
![]() |
![]() |
![]() |
FAQ Index Page | Marine Radios
[ICOM Homepage] [Dealers]
[New
Radios] [Calendar]
[Specials]
[Get
In Touch With ICOM ]
�1997 ICOM America, Inc. The ICOM logo is a registered
trademark of ICOM, Inc. All ICOM radios significantly exceed FCC
regulations limiting spurious emissions. All stated specifications are
subject to change without notice or obligation.