From: Stuart Adams ([email protected])
Date: Mon Feb 19 2001 - 12:55:20 PST
Anyone have some rules of thumb when to use or not use
series damping resistors ??
I am reviewing a design (CPU + ASIC + SDRAM) and they have
used series damping resistors on all the data and address busses
(even for short point to point unidirectional busses)
(15 resistor packs for a total of 120 resistors)
I'm trying to figure out if this is overkill ?? (Typically I
have seen damping resistors used only on the address drivers
for the SDRAM array)
**** To unsubscribe from si-list or si-list-digest: send e-mail to
[email protected] In the BODY of message put: UNSUBSCRIBE
si-list or UNSUBSCRIBE si-list-digest, for more help, put HELP.
si-list archives are accessible at http://www.qsl.net/wb6tpu
This archive was generated by hypermail 2b29 : Tue May 08 2001 - 14:30:53 PDT