Re: [SI-LIST] : 0.5 oz Cu's current density?

From: Doug Brooks ([email protected])
Date: Wed Oct 27 1999 - 09:03:54 PDT

• Next message: Larry Miller: "RE: [SI-LIST] : Heating resistor: RMS or average current (was Re: Effect of low Zo for unterminated lines)"
• Previous message: ken: "Re: [SI-LIST] : About GNDs?"
• In reply to: [email protected]: "[SI-LIST] : 0.5 oz Cu's current density?"
• Next in thread: Farrokh Mottahedin: "RE: [SI-LIST] : 0.5 oz Cu's current density?"

There is a freeware calculator available for download at UltraCAD's web
site. Go to
http://www.ultracad.com
and follow the links to the calculator.

The formulas and their derivations are provided in the help file.

Doug Brooks

At 09:43 AM 10/27/99 +0800, you wrote:
> I am routing a power supply board, but I don't know what trace width I
>should to use to feed a 10A current to load. Can somebody here tell me how
>calculate this? Thanks for any help HanYiZhou
.
****************************************************
Doug Brooks, President [email protected]
UltraCAD Design, Inc. http://www.ultracad.com

**** To unsubscribe from si-list: send e-mail to [email protected]. In the BODY of message put: UNSUBSCRIBE si-list, for more help, put HELP. si-list archives are accessible at http://www.qsl.net/wb6tpu/si-list ****

• Next message: Larry Miller: "RE: [SI-LIST] : Heating resistor: RMS or average current (was Re: Effect of low Zo for unterminated lines)"
• Previous message: ken: "Re: [SI-LIST] : About GNDs?"
• In reply to: [email protected]: "[SI-LIST] : 0.5 oz Cu's current density?"
• Next in thread: Farrokh Mottahedin: "RE: [SI-LIST] : 0.5 oz Cu's current density?"

This archive was generated by hypermail 2b29 : Tue Feb 29 2000 - 11:39:21 PST