From: Chris Cheng (firstname.lastname@example.org)
Date: Fri Nov 19 1999 - 16:22:07 PST
no it doesn't. it only says the 2d transmission line parameters
are calculated in tem mode.
> -----Original Message-----
> From: email@example.com
> [mailto:firstname.lastname@example.org]On Behalf Of Scott McMorrow
> Sent: Friday, November 19, 1999 3:35 PM
> To: email@example.com
> Subject: Re: [SI-LIST] : does PEEC assume TEM mode ?
> >From the manual:
> "PARASITIC PARAMETERS employs a boundary integral equation method
> based on Green's functions for the capacitance calculation."
> "PARASITIC PARAMETERS provides both of the TEM mode inductance and
> the frequency-dependent inductance ... for a 2-D transmission
> line system."
> In reading the manual, PNC uses a filaments approach to develop the
> Partial Equivalent circuit for traces and a cells approach for planes.
> "PARASITIC PARAMETERS automatically generates a non-uniform
> filament mesh across the conductor cross-section by varying the size
> of the filament cross-section."
> I hope this helps.
> Chris Cheng wrote:
> > dear friends :
> > one academic question:
> > does PEEC (partial element equivalent circuit) method
> > uses the TEM mode assumption to generate its model ?
> > i was under the impression it does not but i might be
> > wrong.
> > chris
> > **** To unsubscribe from si-list: send e-mail to
> firstname.lastname@example.org. In the BODY of message put:
> UNSUBSCRIBE si-list, for more help, put HELP. si-list archives
> are accessible at http://www.qsl.net/wb6tpu/si-list ****
> Scott McMorrow
> Principal Engineer
> SiQual, Signal Quality Engineering
> 18735 SW Boones Ferry Road
> Tualatin, OR 97062-3090
> (503) 885-1231
**** To unsubscribe from si-list: send e-mail to email@example.com. In the BODY of message put: UNSUBSCRIBE si-list, for more help, put HELP. si-list archives are accessible at http://www.qsl.net/wb6tpu/si-list ****
This archive was generated by hypermail 2b29 : Tue Feb 29 2000 - 11:39:01 PST