RE: [SI-LIST] : 3.3v and 2.5v LVDS

About this list Date view Thread view Subject view Author view

From: Degerstrom, Michael J. (degerstrom.michael@mayo.edu)
Date: Thu Apr 05 2001 - 12:55:41 PDT


Sreejith,

My 1996 LVDS spec. says that they both have voltage swings about
1.2V. So no special interface techniques are required. That
is say - just use an 100 ohm resistor between true and complement signals
very close to the inut pins.

Mike

_______________________________________________________________
Mike Degerstrom Email: degerstrom.michael@mayo.edu
Mayo Clinic; 200 1st Street SW ; Rochester, MN 55905
Phone: (507) 538-5462 FAX: (507) 284-9171
WWW: http://www.mayo.edu/sppdg/sppdg_home_page.html
_______________________________________________________________

> -----Original Message-----
> From: Sreejith Varma [mailto:varma@blr.paxonet.com]
> Sent: Thursday, April 05, 2001 12:32 PM
> To: si-list@silab.eng.sun.com
> Subject: [SI-LIST] : 3.3v and 2.5v LVDS
>
>
> HI All,
>
> do any one have info on interfacing between a 3.3v LVDS device and
> a 2.5V LVDS device.
>
> regards
> sreejith
>
> **** To unsubscribe from si-list or si-list-digest: send e-mail to
> majordomo@silab.eng.sun.com. In the BODY of message put: UNSUBSCRIBE
> si-list or UNSUBSCRIBE si-list-digest, for more help, put HELP.
> si-list archives are accessible at http://www.qsl.net/wb6tpu
> ****
>

**** To unsubscribe from si-list or si-list-digest: send e-mail to
majordomo@silab.eng.sun.com. In the BODY of message put: UNSUBSCRIBE
si-list or UNSUBSCRIBE si-list-digest, for more help, put HELP.
si-list archives are accessible at http://www.qsl.net/wb6tpu
****


About this list Date view Thread view Subject view Author view

This archive was generated by hypermail 2b29 : Thu Jun 21 2001 - 10:11:28 PDT