UI-View32 Setup

11/30/04

Home
What is APRS?
Equipment is Needed
Software
AGWPE Questions
UI-View32 Setup
WinAPRS Setup

 

 Once AGWPE has been installed and activated, register UI-View 32 and complete the configuration.  **WARNING** DO NOT install PMAP Server until you have installed and registered PMAP 5.0 or 6.0 software
bulletComplete "Station Set-up"
bulletIf mobile, set Unproto Address to APRS, Relay, Wide
bulletIf stationary, set Unproto Address to APRS, the closest Digipeter, and wide
bulletExample:  APRS, W0APR-3, Wide
bulletFixed station beacon should not be less than 30 minutes
bulletAdd your latitude and longitude and you're set.

bulletComplete "Comm Setup"
bulletChange host mode to AGWPE
bulletIf AGWPE is activated and your sound card interface is correctly connected to your sound card you should see APRS stations begin to appear.

 

Home | What is APRS? | Equipment is Needed | Software | AGWPE Questions | UI-View32 Setup | WinAPRS Setup

This site was last updated 10/24/04