To initiate an autopatch, key-up and enter the autopatch access code “*” followed by the Ten digit number with area code. For example (210) 226-3232. Un-key, and the repeater will dial the number. A series of beeps will be generated to indicate dialing in progress.
Key-up, and enter the autopatch access code “*” followed by the ten digit number with area code. Un-key, and the voice will read back the number, wait two seconds and then dial the number. If the number is incorrect, enter the autopatch disconnect code “#” during the two second period. This will terminate the autopatch and prevent a wrong number.
To temporarily suppress the phone number read back, key-click your microphone when you hear the voice say: "AUTOPATCH". The repeater will immediately start to dial the number.
Key-up, and enter the speed dial number. Un-key, and the voice will read back the call letters assigned to that speed dial location, wait two seconds and then dial the number. For example to call kb5ujm key-up and enter 601.
Key-up, and enter the autopatch access code “*” followed by 911. Un-key, and the voice will say: "AUTOPATCH 911" wait two seconds and then dial the number.
To terminate the autopatch key-up, enter the autopatch termination code “#”. Un-key, the autopatch will terminate and the voice will log the time. Example: "Call Complete AT 7:30PM on April 3 thankyou."
To initiate a reverse autopatch, call the repeater by telephone. (210) 399-5454 When the repeater answers the phone a beep will be heard. Enter the reverse autopatch code [800], followed by the speed dial group number (1), (2) or (3) and the table position in that group. You must terminate the entry with a [#]) pound. The repeater controller will key the transmitter, generate a ringing tone and the voice will say the call sign associated with the speed number you entered. For example, if you call the repeater, enter “800” then “101#” the repeater will say: "CALL FOR KB5UJM." To connect the reverse autopatch the mobile operator must key-up and enter [800], the reverse autopatch code.
If during an autopatch, additional time is needed, key-up and send [*1]. This will reset the autopatch timer. The voice will say: "AUTOPATCH TIMER RESET."
If you attempt an autopatch and your call is not completed, the repeater has last number redial. Redial will remain active for a period of ten minutes after the previous call. To place a last number redial call, key-up and send the autopatch access code followed by a [*]. For example, “**”
During an autopatch if additional privacy is required, key-up and send [*3]. This will mute the radio side audio. For the remainder of the autopatch, cover tones will be sent when the mobile transmits.
KB5UJM Repeater Repeater User Commands Echo Link information and Access