Hello all,
I'm using View Logic's XNS for
the post-route simulation of my boards. And facing a peculiar problem.
I'm getting an error message
while trying to run the xfx
command to generate Transmission line Parameter (.tlp) file
.
The error message is :
" conductors <num> and
<num> are touching in CONFIG <num>
"
I tried commenting this
particular configuration in the .xfx file. But this lead me
to errors at a later stage (while building the database for analysis
in XNS).
Is there anybody out there who
faced the same problem with their design ? if yes, what's the remedy
?
Thanks in
Advance
Subramanya
Subramanya C K
Embedded Systems & Internet Access
Solutions Group
Wipro Technologies