From: [email protected]
Date: Fri Dec 15 2000 - 08:05:38 PST
Hi,
I am working on post PCB layout simulation at 3-4 GHz using Agilent
ADS software. PCB layout has been designed in Mentor. I need to use ADS
model for the correct trace/wire length between two pads/microstrips of
the PCB layout. Shall I consider the length of wire between two
microstrips from center to center of a microstrip or edge to edge of a
microstrip?
Considering center to center length is twice that of edge to edge
measurements.
I will appreciate any suggestions.
Thanks.
Manju
Manju Dawande
DELPHI Automotive system
Plant 10, M/S R210
PO Box 9005 Kokomo
IN 46904-9005 USA
E-mail [email protected]
Tel [1]-765-451-9653
Fax [1]-765-451-1787
**** To unsubscribe from si-list or si-list-digest: send e-mail to
[email protected]. In the BODY of message put: UNSUBSCRIBE
si-list or UNSUBSCRIBE si-list-digest, for more help, put HELP.
si-list archives are accessible at http://www.qsl.net/wb6tpu
****
This archive was generated by hypermail 2b29 : Tue May 08 2001 - 14:30:26 PDT