RE: [SI-LIST] : Capacitor dielectric type

From: Doug ([email protected])
Date: Wed Dec 06 2000 - 07:40:50 PST

• Next message: Bill Owsley: "Re: [SI-LIST] : Re: Backplane Board insertion problem"
• Previous message: Dennis Schmitz: "[SI-LIST] : Re: Backplane Board insertion problem"
• In reply to: Mark Gill: "RE: [SI-LIST] : Capacitor dielectric type"
• Next in thread: Michael Nudelman: "Re: [SI-LIST] : Capacitor dielectric type"

This is a dumb question, but the ground and/or chassis connections
are being engaged upon insertion prior to any other connections?

I have worked on a problem where gnd connections weren't done
first upon insertion and that caused a lot of the circuitry to go
into an indeterminate state causing a large current draw.
Solution was simply extending the chassis/gnd pin.

Pretty sure you already know this, but had to ask.

Regards, Doug McKean

**** To unsubscribe from si-list or si-list-digest: send e-mail to
[email protected]. In the BODY of message put: UNSUBSCRIBE
si-list or UNSUBSCRIBE si-list-digest, for more help, put HELP.
si-list archives are accessible at http://www.qsl.net/wb6tpu
****

• Next message: Bill Owsley: "Re: [SI-LIST] : Re: Backplane Board insertion problem"
• Previous message: Dennis Schmitz: "[SI-LIST] : Re: Backplane Board insertion problem"
• In reply to: Mark Gill: "RE: [SI-LIST] : Capacitor dielectric type"
• Next in thread: Michael Nudelman: "Re: [SI-LIST] : Capacitor dielectric type"

This archive was generated by hypermail 2b29 : Tue May 08 2001 - 14:30:22 PDT