[SI-LIST] : PECL oscillator termination

About this list Date view Thread view Subject view Author view

From: Tae-Kwang Jeon ([email protected])
Date: Thu Nov 09 2000 - 11:09:34 PST

Hello everyone,

Here's a question on 3.3V PECL osc. termination.

I know that a Thevenin termination is used on the diff'l outputs of the osc.
But, what i'm concern is the case of AC-coupling to a 50ohm termination.
The qestions occurred to me are;
 #1 Is there any recommended value of the coupling cap?
 #2 How to size the resistors to DC-bias the PECL outputs? Is there also
    any recommended range of size?
 #3 In the case of #2, the resistors are supposed to be grounded, then what
    if I make them in series?
    
Any comments would be appreciated.

Regards,
TK
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
TaeKwang Jeon, LSI Logic Corp.
1525 McCarthy Blvd Phone: (408) 433-6818
MS G-715 Fax : (408) 433-2840
Milpitas, CA 95035 Email: [email protected]
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

**** To unsubscribe from si-list or si-list-digest: send e-mail to
[email protected]. In the BODY of message put: UNSUBSCRIBE
si-list or UNSUBSCRIBE si-list-digest, for more help, put HELP.
si-list archives are accessible at http://www.qsl.net/wb6tpu
****

About this list Date view Thread view Subject view Author view

This archive was generated by hypermail 2b29 : Tue May 08 2001 - 14:30:01 PDT