From: Scott McMorrow ([email protected])
Date: Fri Sep 15 2000 - 13:51:14 PDT
Sean,
Almost every frequency and edge rate today. I would never ship out
a board without performing a crosstalk analysis on every net, especially
those that are on adjacent stripline layers. We often see more than
1 Volt of crosstalk from z-axis parallelism.
regards,
scott
-- Scott McMorrow Principal Engineer SiQual, Signal Quality Engineering 18735 SW Boones Ferry Road Tualatin, OR 97062-3090 (503) 885-1231 http://www.siqual.comSean Murray wrote:
> Does anyone know the formula in order to calculate the coupling percentage > between two signals seperated by a solid ground plane? At what > frequency/edge rate does one have to start thinking about staggering their > traces so that they do not get coupling between two stripline layers.. > > Regards, > Sean Murray > General Manager > > M&M Specialties Inc. > 1236 W. Southern Ave. #106 > Tempe, AZ. 85282-4518 > Phone: (480) 858-0393 x105 > Cell: (602) 684-7859 > Fax: (480) 858-1882 > Email: [email protected] > WWW.mmspec.com > > **** To unsubscribe from si-list or si-list-digest: send e-mail to > [email protected]. In the BODY of message put: UNSUBSCRIBE > si-list or UNSUBSCRIBE si-list-digest, for more help, put HELP. > si-list archives are accessible at http://www.qsl.net/wb6tpu > ****
**** To unsubscribe from si-list or si-list-digest: send e-mail to [email protected]. In the BODY of message put: UNSUBSCRIBE si-list or UNSUBSCRIBE si-list-digest, for more help, put HELP. si-list archives are accessible at http://www.qsl.net/wb6tpu ****
This archive was generated by hypermail 2b29 : Tue May 08 2001 - 14:29:30 PDT