There are two Autocad LISP programs commericially availbale
which can convert polylines with width into zero width
closed polylines.
The contact info for these is given below. Hope it helps.
Regards
Nirmal
CDS Software, John Sovinsky (408-748-0124)
ACS Inc, Hagie Pettel (408-426-6163)
YEE PAK HONG wrote:
>
> Is there any one can advise me the following.
>
> In order to input .dxf into Ansoft/Maxwell S/W, the user needs to ensure
> every trace is in "multiple-lines bounded polyline". But if the user is given
> a "stand-alone polyline drawing", i.e. not bounded by lines, but shaded line,
> how could the user convert such a "stand-alone polyline" to a "multiple-lines
> bounded polyline" in AutoCAD. The method I can think of is to draw additional
> lines and be closed-up upon the edges of the "stand-alone polyline". Please
> advise.
>
>
>
> regards,
> Yee Pak-Hong.
> Texas Instruments S'pore
> MOS Memory Pkgg. Devt.
> DID: (65)290-2206.
> Fax: (65)290-2184.
-- Nirmal Jain Ansoft Corporation (412)261-3200 X129 (W) Four Station Sq., Suite 660 (412)261-471-9427(FAX) Pittsburgh, PA 15219 _________________________________________________________________________ Check out Ansoft's WWW site at http://www.ansoft.com for product information, technical support, employment opportunities, much more... -------------------------------------------------------------------------