I am fairly new to signal integrity simulation, so forgive me if my amateur
inqueries. I use Viewlogic's XTK software for crosstalk simulation (it
compiles IBIS files for all models). I am trying to model a set of active
SCSI terminator in order to analyze a set of differential LVD SCSI signals
(at speeds of up to Ultra3, ie 160Mb/s). I contacted Unitrode and Dallas
but neither could supply me with the appropriate models. How should I go
about modeling these terminators. The IBIS spec was vague about describing
differential signals, what I have done in the past is treat the signals as
single ended models, but this is not a realistic scenario at Ultra-3 speeds.
Any help would be appreciated....
Thank you,
Shahar Bar
Hardware Engineer
American Megatrends, Inc.
6145-F Northbelt Parkway
Norcross, GA 30071-2976
Direct: (770)246-8600 ext. 7125
Fax: (770)246-8765
**** To unsubscribe from si-list: send e-mail to [email protected]. In the BODY of message put: UNSUBSCRIBE si-list, for more help, put HELP. si-list archives are accessible at http://www.qsl.net/wb6tpu/si-list ****