Re: [SI-LIST] : Output Buffer Need

S. Weir ([email protected])
Mon, 19 Jul 1999 15:15:47 -0700

Andy,

The Motorola MPC952 is close to what you ask for.

Regards,

Steve.
At 02:00 PM 7/19/1999 -0600, you wrote:
>Hello all,
> I am currently searching far and wide for a clock fanout buffer
>with the following characteristics:
>
> 1) edge rates faster than 3-4 volts per nanosecond
> 2) 4 or 5 output fanout (1 input)
> 3) low pin-to-pin skew (less than 300 ps)
> 4) 3.3V or 5V Vcc
> 5) max freq around 100MHz
>
>These are the approximate specs I am looking for. The buffer will be used
>on a test board environment, and we require a good, clean, fast edge rate. I
>have seen several datasheets that come close, but either the edge rates are
>not faster than 1V/ns or the part is not near production yet.
>
>Any pointers would be very helpful here!
>
>Thanks in advance,
> Andy Byers
>
>~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
>Andy Byers
>University of Colorado at Boulder
>email: [email protected]
>~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
>
>
>**** To unsubscribe from si-list: send e-mail to
>[email protected]. In the BODY of message put: UNSUBSCRIBE
>si-list, for more help, put HELP. si-list archives are accessible at
>http://www.qsl.net/wb6tpu/si-list ****
>

**** To unsubscribe from si-list: send e-mail to [email protected]. In the BODY of message put: UNSUBSCRIBE si-list, for more help, put HELP. si-list archives are accessible at http://www.qsl.net/wb6tpu/si-list ****