From: D. C. Sessions ([email protected])
Date: Sat May 12 2001 - 06:59:47 PDT
On Thursday 10 May 2001 12:59, Degerstrom, Michael J. wrote:
> Another example is LVDS. I'm not aware of any standard
> dictating this but I think the source impedance of most
> LVDS drivers is much greater than 50 ohms. Sure one can
> implement a LVDS that provides an impedance closer to 50 ohms
> but that design would be very sensitive to power supply noise and
> perhaps to process variations as well.
IEEE 1596.3 -- output impedance must be in the 40-140 ohm range,
but like CML most implementations switch currents into a resistor.
-- | I'm old enough that I don't have to pretend to be grown up.| +----------- D. C. Sessions <[email protected]> ----------+
**** To unsubscribe from si-list or si-list-digest: send e-mail to [email protected] In the BODY of message put: UNSUBSCRIBE si-list or UNSUBSCRIBE si-list-digest, for more help, put HELP. si-list archives are accessible at http://www.qsl.net/wb6tpu ****
This archive was generated by hypermail 2b29 : Thu Jun 21 2001 - 10:11:56 PDT