List updated on Saturday, 21 February 2004

 Autopatch Commands:

   * (star) + telephone number ---> dials telephone number entered

   * (star) + autodial number ---> dials autodial number entered

   # (pound) --> terminates the autopatch / autodial session

   * * (star + star) ---> redials the LAST telephone number dialed

   * * 2 (star + star + 2) --> - mutes repeater user's half of autopatch conversation
                                      (telephone audio is still heard)
                                      - enter command before or during an autopatch call
                                      - selection cancels automatically after call is completed  

   * * 3 (star + star + 3) --> autopatch timer extend - use after controller advises
                                        there is "30 seconds left" to extend autopatch call
                                        for an additional 2 minutes  

 Emergency Autodial Numbers:

  * (star) + 0 --> Operator

  * (star) + 1 --> Maryland State Police

  * (star) + 2 --> St. Mary's County Sheriff's Department

  * (star) + 3 --> U.S. Coast Guard Station St. Inigoes

  * (star) + 4 --> Unassigned

  * (star) + 5 --> Verizon time recording

  * (star) + 6 --> St. Mary's County dispatcher [non-emergency line]

  * (star) + 7 --> Poison Control Center

  * (star) + 8 --> Naval Air Station on-base emergency dispatcher

  * (star) + 9 --> St. Mary's County 911 Emergency line

 Touchtone Pad Test:

   5 + any number of digits  --> repeater reads back digits entered
                                                 in synthesized speech

 Digital Voice Recorder Commands:

   4 + * * * (star + star + star) --> enter command, then unkey.  The next
                                                 transmission will be repeated back to you. 

   NOTE:  See DVR guide (link on previous page) for additional commands  

 Voice Response Telemetry Commands:

  80  --> Time of day (repeater generated)

  815 --> Repeater internal temperature (degrees F)

  816 --> Repeater DC voltage level

  825 --> Number of repeater input keyups

  826 --> Minutes repeater up

  827 --> Number of auto patches

  828 --> Number of mailbox accesses

  829 --> Number of command entries

  831 --> Time out period of last timeout

  832 --> Number of messages in mailbox

 Demo messages:

  30 --> Initial ID message (randomly selected)

  31 --> Forced CW ID message

  32 --> Anxious ID message

  33 --> Pending ID #1 message

  34 --> Pending ID #2 message

  35 --> Pending ID #3 message

  36 --> Special ID message

  37 --> Repeater timeout message

  38 --> Repeater timeout clear message

  39 --> Time of day (repeater generated)

  3 * (3 + star) --> Repeater firmware revision level

 Mailbox Commands:

  Not loaded at this time!  If you'd like to use the mailbox feature to
  leave messages for friends & family members, contact WA3UMY

 Antenna Rotor Commands:

  NOTE:  Rotor commands not yet implemented...
              (beam antennas for the 6 and 2 meter remotes) 

  2 --> Interrogates current direction

  2 + direction in degrees (0-360) --> Points beam in selected direction

  21 --> Turns beam left (counterclockwise) until limit or stop command

  22 --> Stops rotor

  23 --> Turns beam right (clockwise) until limit or stop command

  24 --> Bumps left

  25 --> Bumps right  

 Paging:

  If you'd like to be able to send page tones, contact WA3UMY who can load
  them into the repeater system for you

 Remote Base Commands:

  NOTE:  See remote base document (link on previous page) for commands

 Internet Repeater Linking Project (IRLP) Commands: 

  B x x x x --> Connect to IRLP where x x xx is the 4-digit node number

  B 7 3 --> Disconnect from node x x x x

  NOTE:  see additional instructions in IRLP guide (separate link)