[SI-LIST] : basic design question

From: Adam Klein ([email protected])
Date: Tue Jun 05 2001 - 16:20:48 PDT

• Next message: George Tang: "[SI-LIST] : RE: Shielding Effectivness Question"
• Previous message: S. Weir: "Re: [SI-LIST] : Announcement: Upcoming si-list move"
• In reply to: vinod cr: "[SI-LIST] : RE:"
• Next in thread: [email protected]: "[SI-LIST] : basic design question"
• Maybe reply: [email protected]: "[SI-LIST] : basic design question"
• Reply: Doug Brooks: "Re: [SI-LIST] : basic design question"

I have a 133MHz DUT Board with 50 OHM traces, I have one output from the
tester driving a signal which needs to reach the connector in two different
locations but if I "T" the signal i will receive reflections on the signal
is there another solution which would reduce reflections, and keep the
signal clean.

Thanks
Adam

**** To unsubscribe from si-list or si-list-digest: send e-mail to
[email protected]. In the BODY of message put: UNSUBSCRIBE
si-list or UNSUBSCRIBE si-list-digest, for more help, put HELP.
si-list archives are accessible at http://www.qsl.net/wb6tpu
****

• Next message: George Tang: "[SI-LIST] : RE: Shielding Effectivness Question"
• Previous message: S. Weir: "Re: [SI-LIST] : Announcement: Upcoming si-list move"
• In reply to: vinod cr: "[SI-LIST] : RE:"
• Next in thread: [email protected]: "[SI-LIST] : basic design question"
• Maybe reply: [email protected]: "[SI-LIST] : basic design question"
• Reply: Doug Brooks: "Re: [SI-LIST] : basic design question"

This archive was generated by hypermail 2b29 : Thu Jun 21 2001 - 10:12:16 PDT