From: Chris Rokusek ([email protected])
Date: Mon Jun 04 2001 - 11:16:27 PDT
Richard,
Your first paragraph sounds good to me.
Something else that to consider is that with parallel termination, the wave
flows down the line without a reflection but with source termination the
wave has to travel _twice_ as far before it is absorbed. This seems loosely
like doubling the loop area. Sounds like a good case for
simulation/measurement.
Chris Rokusek
Innoveda
-----Original Message-----
From: [email protected]
[mailto:[email protected]]On Behalf Of [email protected]
Sent: Sunday, June 03, 2001 8:05 PM
To: [email protected]; [email protected]
Subject: Re: [SI-LIST] : Antenna Problem on the Board
To Chris Rokusek, Jian-X. Zheng, Jason Leung, Andrew Martwick and others.
Thanks for the feedback.
The replies got me to really thinking about radiation and impedance. I went
to my ARRL handbook to check out the quarterwave transformer reasoning, and
this seems valid for a special case. But after reading a new book
(Controlling Radiated Emissions by Design by Michel Mardiguian), I'm more
convinced than ever that it is not the higher impedance that gives rise to
greater EMI--it's the height of the trace above the ground plane that is the
governing factor. The common assumption of the replies was that a higher
impedance was caused by a larger height above the ground plane. Obviously
you can get higher or lower Zo by varying the width of the trace while
holding h constant. In this instance, I would say that for a given voltage
across the transmission line, the lower impedance line would produce more
EMI
due to higher line current. This is stated various places in Mardiguian's
book, also.
Nobody replied to my question about the radiation comparison of source
terminated lines to end terminated lines. It seems to me that since you
have
half as much current in a source terminated line, the EMI should be half as
much as a parallel terminated line would produce. Does anyone agree with
me?
I appreciate the help.
Richard Ellison
972-569-8317
**** To unsubscribe from si-list or si-list-digest: send e-mail to
[email protected]. In the BODY of message put: UNSUBSCRIBE
si-list or UNSUBSCRIBE si-list-digest, for more help, put HELP.
si-list archives are accessible at http://www.qsl.net/wb6tpu
****
This archive was generated by hypermail 2b29 : Thu Jun 21 2001 - 10:12:14 PDT