From: Degerstrom, Michael J. ([email protected])
Date: Thu Apr 05 2001 - 12:55:41 PDT
Sreejith,
My 1996 LVDS spec. says that they both have voltage swings about
1.2V. So no special interface techniques are required. That
is say - just use an 100 ohm resistor between true and complement signals
very close to the inut pins.
Mike
_______________________________________________________________
Mike Degerstrom Email: [email protected]
Mayo Clinic; 200 1st Street SW ; Rochester, MN 55905
Phone: (507) 538-5462 FAX: (507) 284-9171
WWW: http://www.mayo.edu/sppdg/sppdg_home_page.html
_______________________________________________________________
> -----Original Message-----
> From: Sreejith Varma [mailto:[email protected]]
> Sent: Thursday, April 05, 2001 12:32 PM
> To: [email protected]
> Subject: [SI-LIST] : 3.3v and 2.5v LVDS
>
>
> HI All,
>
> do any one have info on interfacing between a 3.3v LVDS device and
> a 2.5V LVDS device.
>
> regards
> sreejith
>
> **** To unsubscribe from si-list or si-list-digest: send e-mail to
> [email protected]. In the BODY of message put: UNSUBSCRIBE
> si-list or UNSUBSCRIBE si-list-digest, for more help, put HELP.
> si-list archives are accessible at http://www.qsl.net/wb6tpu
> ****
>
**** To unsubscribe from si-list or si-list-digest: send e-mail to
[email protected]. In the BODY of message put: UNSUBSCRIBE
si-list or UNSUBSCRIBE si-list-digest, for more help, put HELP.
si-list archives are accessible at http://www.qsl.net/wb6tpu
****
This archive was generated by hypermail 2b29 : Thu Jun 21 2001 - 10:11:28 PDT