[SI-LIST] : CardBus input timing measurements condition

About this list Date view Thread view Subject view Author view

From: Haller, Motti ([email protected])
Date: Wed Apr 04 2001 - 08:18:05 PDT


> Hi
> I have A CardBus/PC Card spec Q.
> Looking at the spec for the Setup or Hold times table 5-11 I see contrast
> between remark 3 and the timing measurements condition fig 5-29
> and table 5-12 showing the measurements point and levels.
>
> In remark 3 measurements point are vtl and vth and in fig 5-29 its vih and
> vil and how to use them for rising and falling edges.?
> Can some one make this clear to me ?
>
> What is the input slope for input timing measurements.? I could not find
> them.
>
> <<...OLE_Obj...>>
> <<...OLE_Obj...>>
> <<...OLE_Obj...>>
>
> <<...OLE_Obj...>>
>
> Regards
> Motti

**** To unsubscribe from si-list or si-list-digest: send e-mail to
[email protected]. In the BODY of message put: UNSUBSCRIBE
si-list or UNSUBSCRIBE si-list-digest, for more help, put HELP.
si-list archives are accessible at http://www.qsl.net/wb6tpu
****


About this list Date view Thread view Subject view Author view

This archive was generated by hypermail 2b29 : Thu Jun 21 2001 - 10:11:26 PDT