RE: [SI-LIST] : Re: Open-sink ibis model

From: Muranyi, Arpad ([email protected])
Date: Mon Apr 02 2001 - 12:54:46 PDT

• Next message: AA: "RE: [SI-LIST] : Nyquist Sampling Rate"
• Previous message: Fasig, Jonathan L.: "FW: [SI-LIST] : Cable Shielding: How do you connect the drains?"

Jason,

The first thing you can do is this: Run a simulation
into a resistor that is connected to the same voltage
as the V_fixture parameter in the waveform section of
the IBIS model.

If the simulated waveform does not resemble the waveform
in the IBIS model itself, you have a bad model or bad
simulator.

Arpad Muranyi
Intel Corporation
=============================================================

-----Original Message-----
From: Jason Leung [mailto:[email protected]]
Sent: Friday, March 30, 2001 1:43 PM
To: [email protected]
Subject: [SI-LIST] : Re: Open-sink ibis model

Hi Guys:
I am trying to verify a IBIS model that consists of a open-sink device,
when I use the regular
schematics( i.e. a driver, and a 50 ohms termination in scratchpad ), I
am getting some weird waveform.
Does anyone here know how should I test and verify this IBIS models of a
open-sink device.

Thanks in advance
Best Regards
Jason Leung

**** To unsubscribe from si-list or si-list-digest: send e-mail to
[email protected]. In the BODY of message put: UNSUBSCRIBE
si-list or UNSUBSCRIBE si-list-digest, for more help, put HELP.
si-list archives are accessible at http://www.qsl.net/wb6tpu
****

• Next message: AA: "RE: [SI-LIST] : Nyquist Sampling Rate"
• Previous message: Fasig, Jonathan L.: "FW: [SI-LIST] : Cable Shielding: How do you connect the drains?"

This archive was generated by hypermail 2b29 : Thu Jun 21 2001 - 10:11:24 PDT