
2010 01 12
Added collision detection and alignment to option "Plot text"

2010 01 13
Changed so you can load any (supported) bitmap type as the source map.
Used to be only jpeg.

2010 01 13
If you click ok when you exit Config dialog, sunterm and propagation are switched off.
Otherwise you can end up in an endless loop.
Released version 3.1.4

2010 01 16
Addet lots of controls to the options DialogBox

2010 01 20
Added user frequency to Voacap prediction
Moved tx and rx antenna gain to a text control instead of a spinner control (to be able to enter fraction of a dB)
Added parameters Man made Noise, Minimum takeoff angle, Required circuit reliability, Required signal ratio,
Multipath pwr tolerance, Max tolerable time delay, FoE, FoF1, FoF2, FoEs

2010 01 22
Added parameter direction, tx/rx antenna

2010 01 23
rxgain and txgain were switched - fixed
Auto level implemented
Corrected spelling mistakes and changed some default values. Thanks for your help Jari/oh6bg!
Added link to www.voacap.com on the Voacap tab.
Added checkbox Draw Legend (show values and colours in the lower left corner on the propagation layer)

2010 01 24
Changed "Save bitmap" so the sun term display don't get saved if switched off.
Changed naming of saved bitmaps. Added _SDBW, _SNR, _MUF or _REL to filename (locator) if shown.
Released version 3.1.5

2010 02 17
Legend (if chosen) now also shows in grayscale (if chosen)

2010 05 09
Plot squares can now plot any text file with locators in it. The principle is simple. Load one line and start
at position1 and check if it is a valid locator. If not advance 1 step and try again.

Configuration can be saved as a textfiles. Now you can save and later load different configurations.
All parameters in the configuration dialog is saved!
