MDSR Demodulator-Modulator Software Radio

<body bgcolor="#FFFFFF"> <script async src="//pagead2.googlesyndication.com/pagead/js/adsbygoogle.js"></script><script> (adsbygoogle = window.adsbygoogle || []).push({ google_ad_client: "ca-pub-6390061069482274", enable_page_level_ads: true }); </script><p align="center"><font color="#000000" size="5"><u>MDSR</u></font></p> <p align="center"><font color="#000000" size="4">Modulation Demodulation Software Radio <br> (SDR)</font></p> <p> </p> <p><font color="#000000" size="1" face="Verdana"><strong><u>MDSR based upon SDR</u></strong></font></p> <blockquote> <p><font color="#000000" size="1" face="Verdana">A radio communication system where the modulating and demodulating components that have typically been implemented in hardware are instead implemented using software on a personal computer or other embedded computing devices using by a converter. While the concept is not new, the rapidly evolving capabilities of digital electronics are making practical many processes that were once only theoretically possible!<br> A basic MDSR(SDR) may consist of a computer (PC) equipped with a sound card, or other analog-to-digital converter, preceded by some form of RF front end. Significant amounts of signal processing are handed over to the general purpose processor, rather than done using special-purpose hardware. Such a design produces a radio that can receive and transmit a different form of radio protocol (sometimes referred to as a waveform) just by running different software and any soundcard!<br> The MDSR software performs all of the demodulation, filtering (both radio frequency and audio frequency), signal enhancement (equalization and binaural presentation). Uses include every common amateur modulation: morse code, single sideband modulation, frequency modulation, amplitude modulation, and a variety of digital modes such as radioteletype, slow-scan television, and packet radio. Amateurs also experiment with new modulation methods: for instance, the DREAM open-source project decodes the COFDM technique used by Digital Radio Mondiale and compatible stations.</font></p> <p><font color="#000000" size="1" face="Verdana">demodulator mf 455 khz</font></p> </blockquote> <blockquote> <p><font color="#000000" size="1" face="Verdana">The ideal receiver scheme would be to attach an analog-to-digital converter to an antenna. A digital signal processor would read the converter, and then its software would transform the stream of data from the converter to any other form the application requires.<br> An ideal transmitter would be similar. A digital signal processor would generate a stream of numbers. These would be sent to a digital-to-analog converter connected to a radio antenna.<br> The ideal scheme is, due to the actual technology progress limits, not completely realizable, however.<br> Most receivers utilize a variable frequency oscillator, mixer, and filter to tune the desired signal to a common intermediate frequency or baseband, where it is then sampled by the analog-to-digital converter. However, in some applications it is not necessary to tune the signal to an intermediate frequency and the radio frequency signal is directly sampled by the analog-to-digital converter (after amplification).<br> Real analog-to-digital converters lack the discrimination to pick up sub-microvolt, nanowatt radio signals. Therefore a low-noise amplifier must precede the conversion step and this device introduces its own problems. For example if spurious signals are present (which is typical), these compete with the desired signals within the amplifier's dynamic range. They may introduce distortion in the desired signals, or may block them completely. The standard solution is to put band-pass filters between the antenna and the amplifier, but these reduce the radio's flexibility - which some see as the whole point of a software defined radio. Real software radios often have two or three analog "channels" that are switched in and out. These contain matched filters, amplifiers and sometimes a mixer. </font><font color="#8080FF" size="1" face="Verdana">soundcard, interface</font><font color="#000000" size="1" face="Verdana"><br> </font></p> </blockquote> <p><font color="#000000" size="1" face="Verdana"><strong><u>About the Author of DADP and BiLIF projects </u></strong>Alex Schwarz (VE7DXW) is an advanced HAM and a graduate of the HTL, Innsbruck. He moved to Vancouver (Canada) in 1990 and has since been involved in professional communication systems (LDR trunking) and digital point to point wireless network systems. In 2005 he started work in the Biomedical Engineering Department at C&W Hospital in Vancouver. </font></p> <p align="left"><font color="#000000" size="1" face="Verdana">This website is designed to use with frame-based compatible browsers!</font></p> <p align="left"><font color="#000000" size="1" face="Verdana">These are the links:</font></p> <blockquote> <p align="left"><a href="software.htm"><font color="#000000" size="1" face="Verdana">software.htm</font></a><font color="#000000" size="1" face="Verdana"><br> </font><a href="downloads.htm"><font color="#000000" size="1" face="Verdana">downloads.htm</font></a><font color="#000000" size="1" face="Verdana"><br> </font><a href="about.htm"><font color="#000000" size="1" face="Verdana">about.htm</font></a><font color="#000000" size="1" face="Verdana">,<br> </font><a href="DADP/DADP.htm"><font color="#000000" size="1" face="Verdana">DADP.htm</font></a><font color="#000000" size="1" face="Verdana"><br> </font><a href="MFC/DRM_455kHz_to_LF_Converter.htm"><font color="#000000" size="1" face="Verdana">DRM_455kHz_to_LF_Converter.htm</font></a><font color="#000000" size="1" face="Verdana"><br> </font><a href="BiLif/bilif.htm"><font color="#000000" size="1" face="Verdana">bilif.htm</font></a><font color="#000000" size="1" face="Verdana"><br> </font><a href="leftmenu.htm"><font color="#000000" size="1" face="Verdana">menu</font></a><font color="#000000" size="1" face="Verdana"><br> </font></p> </blockquote> <p align="center"><a href="index.html"><font color="#408080" size="1" face="Verdana">HOME website</font></a></p> </body>