) |
) |
) |
) |
| Bought an GS35-B to get some extra gain. 22-07-2007 |
Drawing the cutting lines on the Aluminium plates. |
Getting started with the Cabinet. HV TR. 3800V. | Added middle and front section and Tube case. |
) |
) |
) |
) |
| Placed the 120pf air C,30pf Vacuum C and the HV.RFC. | Tube Socket made by PA3AOT.Left the input swr C. | Tube clamps made of copper strips, behind this the Filament Choke. | Placed the vacuum relais , and testing the in and output. |
) |
) |
) |
) |
| HV Divider board. | Made de Shimmy of 1.2mm Teflon. | Had to shorten the Plate tank Coil | G3SEK Board.tested by PA3AOT. |
) |
) |
) |
) |
| Elco Board. | Soft start Step up board. | Filament board with the Filament transformer 12,6v. | |
) |
) |
) |
) |
| First 24 Heating Hours for the New TUBE. | Unfortunately died the first transfr. So had to replace it with an 2850V. | Testing frequency and swr of the Amplifier. | Just connected the antenna and hope that it works |
) |
) |
||
| Power input 50wt and output 800wt. 19-04-2008 | Side,Top & Front cover are Temporary... |