3.0.0 FUNCTIONAL CONTROL
All functions and operating procedures are controlled by the Pentium
computer running Custom executable LabView 5.01software. The
software has been compiled and turned into an executable file and thus
does not require that the end user have access to labView development
software. To control the Galil motion controller hardware.
There are two modes of operation for running profiles. First is the
stored profile mode, which has an unlimited number of banks of twelve
selectable profiles. The system maintains the flow rate by varying the
Revolutions Per Minute (RPM) of the motor according to the flow
changes of the profile selected. The amplitude control will vary the flow
of the profile from 10 to 450 LPM. The BPM control varies the breath
rate and will not change the flow rate.