2.1.1.13 Delay & Phase control (marker #13 of image 2.1.1)
When the operator has elected to have to units active, then it is possible to synchronize the to units using unit 1 as a reference.
DELAY - The operator can set unit 2 to delay its start until after unit 1 has performed x number of breath cycles.
PHASE - The operator may offset unit 2 to begin its start after x number of data points have occurred in unit 1 cycle ie. ( if unit 1 has a total of 100 points per full cycle then setting phase to 50 will cause unit 2 to begin its cycle 180 degrees out of phase with unit 1)
Note: If phase is larger than total number of points per cycle of unit 1 then the phase will be equal to setting a delay of phase/points per cycle with the remainder being the phase offset.
both Delay and Phase can be used simultaneously.