From: wa2ise@cbnewsb.cb.att.com (robert.f.casey) Subject: DR110 mod file Keywords: mods Date: 3 Jul 91 00:21:52 GMT Organization: AT&T Bell Laboratories Lines: 20 copied from packet: >From: "CARTY ELLIS (KA2Y)" >Subject: ALINCO DR-110T MODS To broadband the DR-110T, while holding the "F" and "VFO/M" keys down, turn off the power and then turn it back on (still holding the keys). The radio now has factory programming reset - you just lost your memories but at least mine now transmits and receives from 130 Mhz to 169 Mhz. Before you do this, remove the top cover - notice the long (2 inchish) loop of yellow wire coming off the back of the front panel - clip it! NOW - after resetting the microprocessor - press the "F" key, then press the "Mhz" key (mine now says 370). press the "f" key again, then press the "Mhz" key again - (mine now says 870!). Mine will scan from 870.000 to 889.995 Mhz. I selected a 15Khz step because the channel spacing in this range is 30 Khz. Toggle the "F" and "Mhz" keys and you're back at 144 mhz. Enjoy. -------------------------------------------------------------------------- Note: I haven't tried or verified this, proceed at your own risk. WA2ISE  Copied from the QRZ! Windows Ham Radio CDROM