Frequency expansion

Remove the bottom cover (8 screws: 4 underneath, 2 on each side)

Remove the plastic rear panel. (Just a cosmetic piece)

Remove the rear metal panel. (So many screws)

Loosen the "hinge" screws on the front bottom. There are 4 of them.

Lift the now loose card tray to expose to inner circuit boards. Be careful! There are two power supply lines

that need to be disconnected. (Remember to reconnect them on assembly.)

(one is the control board, the other the one we want.) Note that the board we will mod is the same one that has

the switch that allows changing the tuning dial from 5kHz/rev to 10kHz/rev.

Change the position of switch S01. The rig will now transmit from 1.5 to 29.99999 MHz.

Reverse the disassembly procedure.

Well that's it. You are now ready for any band addition that may come our way.