RX-TX expanded range for YAESU FT26 handheld.

Make FT26 open and locate straps 1 to 8 on the "CONTROL UNIT".

Now you must close the following straps : 1, 3, 5, 7, 8. Close your FT26 and turn the power on while

keeping at the same time the "TONE" and "REV" depressed. Now you need reprogramming low and high

frequency edge : When "1" is blinking enter RX lowedge and then push

"D/MR" ....."2"...................RX high.................."D/MR" ....."3"...................TX low...................

"D/MR" ....."4"...................TX high.................."D/MR"

You can reprogram your "ARS" like in the OPERATING MANUAL page 21.

Note: I haven't tried or verified this, proceed at your own risk.

And do not transmit outside of legal bands!