Extended RX/TX for Alinco DJ-162

1. Remove the battery pack.

Remove the battery plate from the bottom of the radio.

2. Remove the back cover from the radio. This is a tedious process. You must take the knobs

off the top and remove the top plate first.

3. Under the Battery clasp on the side of the radio (The little sliding thumb switch that keeps the battery

from falling off the radio) you will find a yellow loop of wire. This loop is small and hard to get to.

You will need a very small pair of cutters or scissors. --Cut this wire.

4. Put the radio back together

5. Reset the radio. (You will lose your memories)

6. Go to the VFO mode. Pressing the 'B' key on the keypad will now allow you to cycle through

the extended rx bands. It will cycle from 2 mtrs, am aircraft, to 800. The radio does NOT have

the guts to receive 800. It just happens to be in the processor so don't waste your time listening.

7. This same jumper also opens extended transmit.