================================================================================
                           TRIO-KENWOOD mods and remarks
                        -< Include 0-150kHz on your TS430 >-
--------------------------------------------------------------------------------

This modification is to include the receiving range from
the TS430 from 0-150 kHz.

Connect a resistor of 1K from IC1 pin 14 to ground in
the PLL Unit.

(Pin 14 from IC1 goes to the base of a transistor.)

The best way to do this, is by soldering the resistor at
the solder side of the PLL Unit PCB.

thanks to;
Peter  -PA3AEF-