AM receive:

1. remove top and bottom covers, then remove speaker.

2. Lift the faceplate retaining tabs on top and bottom to slide the face off (pull the knobs off first you knob).

3. remove the retaining nut on the tuning shaft and lift the clear plastic light guide off.

4. The 12 surface-mount sized jumpers are now visible.

5. If AM is disabled, there should be a jumper across number5. Remove this and reset radio before use.

(I think it is number 5, my radio had only one jumper in place, and it was the one for AM block-out.

If you have more than one in place, contact me and I will give you the double-checked version of this mod.)

Is it common for a radio to require a jump *made* instead of just *cut*? This would have to be the case

for this model since it doesn't have any jumpers soldered into place.

(12 pairs of surface-mount sized/spaced pads numbered from left to right).