                   YAESU FT890/AT mod.  TX 1,5 to 30 MHZ.
                   ======================================
 
 - Disconnect FT890 from all connections.
 
 - Open tranceiver like explained in your "OPERATING MANUAL".
 
  -  Locate  on  the  "CONTROL  UNIT" jumper point JW 3001 and close it with
solder.
 
 - Close tranceiver back and reconnect power.
 
 - Push PROC, AGC-F, IPO, ATT while power ON.
 
  -  Now the display shows two digits of numbers and tree of letters (i.e 13
OFF)  Rotate  main  knob  and set the display to "02 ON". Now press the PROC
button.
 
 - Power OFF and then back ON. It's all!
 
 - Now every time you want, you can change the programation, but you will
   allways lose the memories.
 
 - Other settings than "02 ON" are of no interest. This one give you 100 w
   and automatic antenna tuning between 1,5 and 30 mhz.
 
 



     *================================================================*
     *    << BBS "ARACHAN" CX3VB >> - << CX3VB-6 APRS Digipeater >>   *
     *----------------------------------------------------------------*
     *   HF 7.040 Khz  VHF 145.010 Khz  AX25 CX3VB@CX3VB.CELA.URY.SA  *
     *   E-Mail cx3vb@qsl.net  -  cx3vb@amsat.org (Solo Texto plano)  *
     *----------------------------------------------------------------*
     *  Jose Maria Techera - Melo, Cerro Largo, URUGUAY, SA (GF27WO)  *
     *================================================================*


