For some time now I have wondering about reducing the power output on my Yaesu 

HELLO ALL

FT747GX, in the SSB mode.
I have looked at using the external ALC to do this, but did not wish to have 
another lead running out of the back of the radio.
I looked at the schematic of the rig and decided that if I removed the diode D99 
from the circuit, I would be able to utilize the drive control on the front 
panel to reduce power in SSB mode.
After removing the top cover from the radio, I removed the screw holding the 
crystal filter board in place and removed the board (simply lift squarely), 
under the board you will see D99 marked on the main board.
I just cut the lead to the diode so as to allow reconnection at any time. After 
I had done this mod I replaced the crystal filter board (and screw) and tested 
the rig.

The results were excellent, I have full control of the power from 100W down to 
less than than 50mW.

I tested the rig on air and worked a station about 2 miles away with 250mW, on 
the 7 Mhz band, Below that level I was drown out with QRM.

After looking at the prices of some of the commercial QRP rigs available I feel 
that the FT747 is a rig looking at, I also intend to use it for driving a 
transverter.

73 de CX3VB  JOSE MARIA




     *================================================================*
     *    << BBS "ARACHAN" CX3VB >> - << CX3VB-6 APRS Digipeater >>   *
     *----------------------------------------------------------------*
     *   HF 7.040 Khz  VHF 145.010 Khz  AX25 CX3VB@CX3VB.CELA.URY.SA  *
     *   E-Mail cx3vb@qsl.net  -  cx3vb@amsat.org (Solo Texto plano)  *
     *----------------------------------------------------------------*
     *  Jose Maria Techera - Melo, Cerro Largo, URUGUAY, SA (GF27WO)  *
     *================================================================*
