FT-7400
By Jay Urish KB5VPS

This is the mod for a Yaesu FT-7400H UHF rig. I personnaly developed
this mod myself so use it at your own risk!!!

You will need a fine tip soldering iron for this job. You will also
need a phillips screwdriver.

1)remove the small top lid--It is held on by 5 screws.
2)remove the ground lead to the faceplate on the front left of the rig.
3)remove  the  2 allen head screws from the front faceplate andlay it on its
face.
4)locate the row of solder pads by the CPU/battery.
5)The pads are numbered 1 - 6 from left to right.
6)In order to open the tx/rx to 418-470 you need to jump pads 1,2,4,6
7)You shouldn't have to reset the rig. Mine came up imediately.


Notice!!!! The VCO won't lock below 425Mhz--If it does the audio will
have a high pitched whine to it. The top end seems to be about 468
before the VCO starts to have a problem.

Another thing I found out-- Jumper #4 is what tells the cpu ir the rig
is a 2400 or a 7400.

Sensitivity does not seem to be affected..

Enjoy!





     *================================================================*
     *    << BBS "ARACHAN" CX3VB >> - << CX3VB-6 APRS Digipeater >>   *
     *----------------------------------------------------------------*
     *   HF 7.040 Khz  VHF 145.010 Khz  AX25 CX3VB@CX3VB.CELA.URY.SA  *
     *   E-Mail cx3vb@qsl.net  -  cx3vb@amsat.org (Solo Texto plano)  *
     *----------------------------------------------------------------*
     *  Jose Maria Techera - Melo, Cerro Largo, URUGUAY, SA (GF27WO)  *
     *================================================================*

