FT 4700 Mod

FT-4700 Frequency expanding modification.
Following example shows programming for 138-174Mhz, and 420-460Mhz.

1. Remove front panel.

2. Locate jumper spots 1,2,5,9,10,13 and short them with solder carefully.

(Other jumper spots must remain as current on the control unit.)


3.  Turn  power  on,  and  set  the  display  for the lower edge of UHF band
(420.000),u sing up/down buttons, and dial. Then press D/MR button.


4.  Set  the  display  to 460.000 and press D/MR. The display shows 47.75(if
frequency of uhf). Press D/MR, and then uhf coverage i programmed.


5.  Set the display freq. to 138.000 and press D/MR. Then set to 174.000 and
pres s D/MR again. the display now shows the VHF if req. at 17.3. Press D/MR
again. Now both band coverages are programmed.


6.  After  this modification the repeater shift is set to 000mhz, so it must
be  se  t  using  the  F  and RPT buttons on both bands. Re er to page 27 of
manual for details.


7.  Remember that transmiting outside the amateur bands is prohibited unless
you have a special licence.




     *================================================================*
     *    << BBS "ARACHAN" CX3VB >> - << CX3VB-6 APRS Digipeater >>   *
     *----------------------------------------------------------------*
     *   HF 7.040 Khz  VHF 145.010 Khz  AX25 CX3VB@CX3VB.CELA.URY.SA  *
     *   E-Mail cx3vb@qsl.net  -  cx3vb@amsat.org (Solo Texto plano)  *
     *----------------------------------------------------------------*
     *  Jose Maria Techera - Melo, Cerro Largo, URUGUAY, SA (GF27WO)  *
     *================================================================*


