Subject: Yaesu FT-2200 2m mods
From: tskloss@zeus.tamu.edu (SKLOSS, TIMOTHY WILLIAM)


	I bought my ft-2200 a few months ago and I didn't have the AM recieve
activated.  So I complained and got the mod for it:

	AM receive:  

		1.  remove top and bottom covers, then remove speaker.
		2.  Lift the faceplate retaining tabs on top and bottom to
		    slide the face off (pull the knobs off first you knob).
		3.  remove the retaining nut on the tuning shaft and lift
		    the clear plastic light guide off.
		4.  The 12 surface-mount sized jumpers are now visible.  
		5.  If AM is disabled, there should be a jumper across number
		    5.  Remove this and reset radio before use.  (I think it
		    is number 5, my radio had only one jumper in place, and 
   		    it was the one for AM block-out.  If you have more than one
		    in place, contact me and I will give you the double-checked
		    version of this mod.)

  Now, if you enjoy this mod, please send me any more that you have heard of
for this model. I would like a wide open radio to experiment with it's power
output across the spectrum. I need FM Rx and Tx extended.

Is  it  common  for  a radio to require a jump *made* instead of just *cut*?
This  would  have  to  be  the case for this model since it doesn't have any
jumpers  soldered  into  place. (12 pairs of surface-mount sized/spaced pads
numbered from left to right).

thanks in advance!

/------------------------------------------------------------------\
|* *(* (**)(* *)* *)*|           Tim Skloss   KC5DNA               |
|*  *   \/  \/  *   *|  Texas A&M University, Dept. of Chemistry   |
|*    /=========\   *|       College Station, TX 77843-3255        |
|*    | OXFORD  |    |     LABORATORY FOR MAGNETIC RESONANCE       |
|     |  mags.  |   *|           AND MOLECULAR SCIENCE             |
|*    |  RULE!  |    |           voice: (409) 845-4459             |
|     |_________|    |           fax:   (409) 845-4719             |
|      ||     ||     |     Internet:  TSKLOSS@venus.tamu.edu       |
|      ==     ==     |  My opinions do not reflect those of TAMU!  |
\------------------------------------------------------------------/
                 "The brain is much like a computer;  
therefore dumb people do not really exist, just people running DOS!"  
          PowerPC - The ULTIMATE personal computing machine.


-------------------------------------------------------------------
Date: Sat, 21 Nov 1998 01:53:58 -0500
From: WonderBoy <WonderBoy@Sprintmail.com>

How to expand the TX of a Yaesu FT2200

Information provided by Yaesu Techs.

This is a very involved process, if you need help, just do not attempt this.

1. Disconnect the power cable from the radio.

2.  Remove  the  bottom  lid (same side as the speaker), careful the speaker
will drop out.

3. Remove the speaker.

4. Cut the green wire found under the speaker.

5. Reattach the lid to the radio.

6. Reconnect the power cable.

7.  Reset  radio  by pressing the MHz and Call buttons together and power up
the radio

Old TX is 144.000 to 148.000 MHz. Old RX is 144.000 to 174.000 MHz
New TX is 140.000 to 175.000 MHz. New RX is 110.000 to 180.000 MHz

NOTE:  Any freq under 140.000 MHz is RX as AM, and a star will appear on the
display. Do not use a modified radio for any bad things. This information is
given freely and what you do with it is your business.





     *================================================================*
     *    << BBS "ARACHAN" CX3VB >> - << CX3VB-6 APRS Digipeater >>   *
     *----------------------------------------------------------------*
     *   HF 7.040 Khz  VHF 145.010 Khz  AX25 CX3VB@CX3VB.CELA.URY.SA  *
     *   E-Mail cx3vb@qsl.net  -  cx3vb@amsat.org (Solo Texto plano)  *
     *----------------------------------------------------------------*
     *  Jose Maria Techera - Melo, Cerro Largo, URUGUAY, SA (GF27WO)  *
     *================================================================*
