Date: 2 Jun 89 16:07:14 GMT

From:  pasteur!navajo.berkeley.edu!bilbo@ucbvax.Berkeley.EDU (Bill Baringer)
Subject: FT-209RH mods resolved

Some  time  ago  I had tried the FT-209 mods as published in the Dec. '87 73
magazine.  It  hadn't worked correctly, and someone on the net verified that
the  jumpers  listed  weren't  correct,  but  they'd  forgotten  the correct
jumpers.  Well  I  finally  got  around  to  doing the mod, and here are the
results.

The magazine article says to jump pins 1, 7, 9, 10, 11, 13, and 16. In every
209RH  I've  opened, pins 1, 9, and 13 are already jumped. Adding jumpers 7,
10,  11  and  16 allows "out-of-band" transmission. But the receiver becomes
thoroughly confused, and is not tunable. The solution: DON'T jump 11 and 16.

So the final steps are:
1) Add jumpers to 7 and 10.
2) Give the VCO can a 1/2 turn clockwise if you're moving to higher freqs.
3) Reset radio and reprogram rcv and xmit freqs, and rptr offset.

Hope this helps!

Bill      -KI6DG


All the usual disclaimers apply.




     *================================================================*
     *    << BBS "ARACHAN" CX3VB >> - << CX3VB-6 APRS Digipeater >>   *
     *----------------------------------------------------------------*
     *   HF 7.040 Khz  VHF 145.010 Khz  AX25 CX3VB@CX3VB.CELA.URY.SA  *
     *   E-Mail cx3vb@qsl.net  -  cx3vb@amsat.org (Solo Texto plano)  *
     *----------------------------------------------------------------*
     *  Jose Maria Techera - Melo, Cerro Largo, URUGUAY, SA (GF27WO)  *
     *================================================================*

