copied from packet: 
Subject: Icom IC-28 squelch modification 
 
The long, noisy squelch-tail of the Icom IC-28 (A or H model) 2-meter  
transceiver can be shortened by replacing C110 (4.7 uf) with a smaller  
value (0.1 to 0.47 uf).  (I can't remember the source of this  
information.) 
 
I put a 0.33 uf in my IC-28H; it's a very worthwhile modification. 
 
The capacitor is on the bottom board (the one with the lithium  
battery), just southeast of IC4 as you face the front of the upside- 
down radio.  The only difficult part is finding the right p-c pads to  
desolder on the back of the board. 
 
To remove the board:  Remove bottom plate, unplug speaker.  Unplug  
coaxial antenna connector (gray wire).  Other connectors may remain in  
place.  Remove 5 mounting screws, one in each corner and one near  
center.  Tilt the board out of the radio.  The button in the upper  
left corner is CPU reset; you may have to reprogram the memories if it  
is pressed.  Remember that, although the radio is off, parts of the  
circuit are still "hot" because of the memory-backup battery, so be  
careful not to short any part of the board during the modification. 
 
-- 
 
Frank      W9MKV 
 
Note: I haven't tried this, proceed at your own risk! WA2ISE 
 
 
 
